Honda XR100 License Plate Mount Installation Instructions
Required Tools: Drill with 1/8” and 1/4” drill bit, ratchet with 10mm socket, 4mm allen key, permanent marker.
Warning! Sharp tools are used in this installation. Take proper precautions to prevent injury!
- If no offroad plate or mount is currently installed, place the 3DC License Plate Bracket into position under the rear fender.
- Align the narrow part of the mount as straight as you can and mark the holes with the permanent marker.
- Using a 1/8” drill bit, pilot drill the four holes. If not centered, move to a slightly larger bit and correct the hole to the center of the mark.
- Using the 10mm socket and the 4mm Allen key, install the provided hardware to mount the plate bracket on the fender.
- Install your offroad license plate.
- Go get dirty!
FIG. 1
FIG. 2
FIG. 3
FIG. 4
